Bob Smith Insta-Cure Super Thin CA Glue 2oz

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.

Unscrew top from nozzle. For finer applications, use the extender tip. Insta-Cure™ CA is used to bond tight fitting parts. Hold the parts together (sometimes using masking tape), then apply the Insta-Cure™ along the joints. The CA will penetrate deep into the joints. Bonding will occur in 1-3 seconds. Excess cured CA can be removed from surfaces like ceramics by rubbing with a paper towel soaked in Un-Cure™. Full strength is reached in two hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220º F. Soak extender tip in acetone for cleaning.

Note: The products shown in photos have been professionally painted. Color swatches are for informational purpose only and may differ from the actual merchandise. Colors on your screen are also affected by monitor settings and browser.

Safety Warning: Products may contain sharp points, small parts, choking hazards, and other elements not suitable for children under 12 years old.

Hazardous products like paint, cement, glue, thinner, etc. must be shipped by ground (USPS First Class Package, USPS Parcel Select, UPS Ground) inside the U.S only (no Alaska, Hawaii, Puerto Rico, U.S territories, APO address). They also cannot be shipped to a P.O Box.